What processing operation modes does the tufting machine have? -Jiangmen Xinhui District Meixin Brush Manufacturing Co., Ltd.

What processing operation modes does the tufting machine have? 2020-07-07 19:26:32

　　 Brush-making equipment The tufting machine has equipment in many brush-making factories. There are many processing methods, such as mechanical / semi-automatic / fully automatic. Today, the editor of the tufting machine will introduce to us several processing methods about the tufting machine.

　　Brush making equipment tufting machine

　　Mechanical

　　 is the continuous processing of products, without stopping in the middle, unless you press the 'Stop' button, only place more than 2 fixtures At this time, the cycle processing of the product can be ended. Fully automatic processing can increase the output power. When the product on the first fixture is processed and the product on the next fixture is processed, the product on the first fixture can be replaced, and the product on the next fixture can be replaced at the top of the list. Finish the reciprocating processing of the products on each fixture. If only one fixture is placed, only the semi-automatic processing mode can be used. In the standby state, press the number key '1' on the panel to enter the fully automatic working method. When the protection occurs, the entire machine will stop. After repairing, move the machine head to the high position and use the 'single step' key to find Press the 'Preliminary' button to process the empty position. Otherwise, the process of pressing the preliminary key will cause heavy holes in the originally processed hole position, which may damage the needle. You must be careful during operation, and you should also be careful during semi-automatic processing.

　　semi-automatic

　　 press the 'preliminary' button once to process once, after the product is processed, the machine head stops at the high position and the work reaches the starting point. To replace the product, press the 'Preliminary' button again, work to the first hole position, and process again, or from the Nth hole to the final hole, N can be set, you can enter the hole number through the keyboard and press on When the hole and the lower hole key work to the hole, make sure that the hole position must not be processed, and then press the 'preliminary' button to process, otherwise the needle will be damaged. When protection occurs, the processing method is the same as that of fully automatic processing.

　　Fully automatic

　　 After setting the product data, press the 'Upper Hole' or 'Down Hole' button on the automatic test machine screen to end the single-step hole alignment. Find out if the orientation of the hole is wrong, if it is wrong, you can exit and enter the experience correction interface to make corrections. After the initial press, the workbench will continue to move until the completion of a product program file and stop working, so that it can be checked whether the workbench is normal.