What are the processing methods of the tufting machine-Jiangmen Xinhui District Meixin Brush Manufacturing Co., Ltd.

What are the processing methods of the tufting machine?

　　 Brush-making equipment The tufting machine has equipment in many brush factories. There are various processing methods, such as mechanical/semi-automatic/automatic. Today, the editor of Meixin high-speed broom machine will introduce to you several processing methods about tufting machine.

　　Mechanical

　　 is the continuous processing of products, the center does not stop, unless the 'intermittent' button is pressed, as long as more than 2 fixtures are placed, the cycle processing of the product can be completed. Fully automatic processing can increase the output power. When the product on the first fixture on the list is processed and the product on the second fixture is processed, the product on the first fixture can be replaced, and the product on the second fixture can be processed. Replace the product on the first fixture on the list to complete reciprocating processing. If only one fixture is placed, only the semi-automatic processing mode can be used. In the standby state, press the number key '1' on the panel to enter the fully automatic working method. When maintenance occurs, the whole machine moves intermittently. After repairing, move the machine head to the high position and use the 'single step' key to find Press the 'Preliminary' button to process the empty position. Otherwise, the process of pressing the preliminary key will cause heavy holes in the originally processed hole position, which may damage the needle. You must be careful during operation, and you should also be careful during semi-automatic processing.

　　semi-automatic

　　 press the 'preliminary' key once to process once, after the product is processed, the machine head is interrupted at the highest position and the work reaches the starting point. To replace the product, press the 'Preliminary' button again, work to the first hole position on the list, and process again, or from the Nth hole to the final hole, N can be set, you can input the hole number through the keyboard and press on To make sure that the hole must not be processed, press the 'Preliminary' button to process the hole, and the lower hole key will work to the hole. Otherwise, the needle will be damaged. When maintenance occurs, the processing method is the same as that of fully automatic processing.

　　Fully automatic

　　 After inputting the product data, press the 'Upper Hole' or 'Down Hole' button on the automatic test machine screen to complete the single-step hole alignment. Check whether the hole position is wrong, if it is wrong, you can exit and enter the experience correction interface to make corrections. After the initial press, the workbench will continue to move until the intermittent work of a product program file is completed, so that it can be checked whether the workbench is normal.