The processing method of broom tufting machine

Automatic processing of broom tufting machine: It is continuous processing of products, without stopping in the middle, unless the 'stop' button is pressed, only when more than 2 fixtures are placed, can the product cycle processing be realized. Fully automatic processing can improve production efficiency. When the product on one fixture is processed and the product on the second fixture is processed, the product on one fixture can be replaced. When the product on the two fixtures is processed, the product on one fixture can be replaced. products, to achieve reciprocating processing. If only one fixture is placed, only semi-automatic processing mode can be used. In the standby state, press the number key '1' on the panel to enter the fully automatic working mode. When the protection is displayed, the whole machine will stop. If the hole is empty, press the 'Start' button to process, otherwise, in the original processed hole, pressing the start button will cause heavy holes, which may damage the needle. Be careful when operating, and you should also pay attention to semi-automatic processing. Semi-automatic processing: Press the 'Start' button once to process once. After processing the product, the machine head stops at a high position and runs to the starting point. Replace the product, press the 'Start' button again, run to a hole position, and process it again, or start processing from N holes to a hole, N can be set, after entering the hole number through the keyboard, press Up Hole, Down Run the hole key to the hole, make sure that the hole position has not been processed, and then press the 'Start' button to process, otherwise the needle will be damaged. When there is a fault, the processing method is the same as that of automatic processing. For more information about high-speed tufting machines, tufting machines, and toothbrush tufting machines, please pay attention to the update of our website