The length of the mechanical service life of the tufting machine depends largely on the amount of wear during the running-in period

The management department of tufting machine machinery and equipment did not implement the importance of machinery maintenance to every person related to machinery, which led to the fact that machinery maintenance is only a slogan of the corresponding management department. Many construction units always think that the quality of the mechanical technology is mainly determined by the repair unit. They think that the mechanical failure of the tufting machine and the inability to work are due to the failure of the repair unit to keep up with the repair force and poor ability.

The length of the mechanical service life of the tufting machine depends largely on the amount of wear during the running-in period. The first time a new car is used, it must be run-in. Generally, the running time of construction machinery should be more than 100 hours, and the load should be less than 80%. Some construction companies do not pay attention to running-in, and the new machinery purchased is directly put into use. For new machines or mechanical equipment after overhaul, good running-in must be carried out. During the running-in period, the driving speed should be controlled, the workload should be reduced, and maintenance should be strengthened.

In order to reduce the wear of the engine at startup, you can use the hand crank to rotate the crankshaft of the engine before starting, try to make the engine oil reach the friction surfaces first, do not let the engine turn off when stopping for a short time, the engine should not be started for more than 30 seconds at a time, and should be started twice The interval should be one minute. If the continuous starting time is too long, it will affect the service life of the battery and the starter motor. Especially in the cold winter, it should be noted that the engine cannot be started after more than three times. It can be started again later, Foshan MX brushmachinery Machinery Factory http://www.mxbrushmachinery.com/

With the continuous development of science and technology, more and more new technologies, new materials, new processes and new functions are continuously integrated into construction machinery equipment, which has higher and higher requirements for construction machinery equipment operators. The good technical level of operators can greatly improve the utilization rate and integrity rate of construction machinery, avoid damage to construction machinery caused by human factors, shorten the maintenance time and cycle of construction machinery, and create good economic benefits for enterprises.