Hair planting machine_high-speed hair planting machine_brush making equipment7

MX machinery:

1. The waste hair of bristle brush and wool brush is not clean. ① Increase the rotation speed of the roller and slow down the transmission speed of the chain; ② Try to adjust the brush as close to the direction of the roller as possible, as long as the needle does not touch the filling strip in the brush head without damaging the bristles. 2. The filaments of the wire brush are twisted and deformed, which mainly reduces the speed of the rollers, and at the same time, the speed of the chain transmission can be adjusted faster. 3. The rubber chain in the bottom row is easy to drop the rubber or the chain makes an abnormal sound, sort out the waste hair in the double-row sprocket groove in time, add lubricating oil (evenly, a little), and tighten the chain. 4. The brush head is simply sucked into the machine compartment. ①Adjust and tighten the screw to compress the brush head; ②Clean the thickness of the brush head; ③The brush head cannot be in the shape of a waist drum (the center protrudes); ④If it is a drum shape, leave a gap between the brush head and the brush head There are gaps. 5. The adjustment speed of the inverter is unstable. If the rotary adjustment switch is used, the adjustment switch is likely to be damaged. Refer to the 'Instruction - Function Parameter List' to correct the parameters, and change F0.00-0 to F0.00-1, so that the speed can be set with the up and down keys. 6. The sound of the machine just started is abnormal. ①Perhaps there is a lack of phase, check the circuit; ②Check the contactor, the voltage is unstable, and it is easy to damage the contactor; dust entering the contactor is also likely to cause poor contact, dust removal or replacement of the contactor. 7. The machine trips. Check the circuit and check one by one, it is very likely that a motor is burned out and short-circuited. Pay attention to the lack of phase, the lack of phase will easily damage the motor. 8. The machine has induction electricity, and the ground wire must be connected well.