Discussion on Common Fault Situations of Tufting Machine and Causes of Bad Finished Products_Latest News

First: copper wire is easy to bend

1. The copper cutting part of the tufting head is worn and replaced

2. The copper cutting knife is worn and replaced

3. Improper adjustment of hair-planting head and copper cutter, re-adjust

3. There are foreign objects on the contact surface between the hair-planting head and the heart of the hair-planting head, remove and clean

4. Improper adjustment of the height of the copper cutting knife. Re-adjust the copper wire adjustment too long. Shorten the copper wire

5. The quality of the copper wire is poor, such as bending, too wide or too thick, replace the new copper wire



Tufting machine pictures

Second: the size of the copper wire, the length of the copper wire after cutting is different

1. The copper wire clamp is worn out, re-grind or replace it

2. The copper wire backstop is worn out. Use or replace the copper wire backstop.



Picture of high speed tufting machine

Third: The angle at which the copper wire enters the brush handle is incorrect, causing the copper wire to fail to catch the bristles or the copper wire to fall off easily

1. The size of the copper wire refers to the size of the copper wire

2. Copper wire adjustment is too short and lengthened

3. The distance between the hair planting head and the brush handle is too large when planting hair. Adjust the distance before and after

4. The front end of the hair-planting needle is worn and ground or replaced

5. The outlet piece at the front end of the tufting head is worn, replace the tufting head



Fourth: Insufficient pulling force of the bristles

1. The copper wire is too short, lengthen it

2. The depth of flocking is not enough. Adjust the length of the flocking needle. The length of the bristles is uneven (all) Improper adjustment of the upper and lower positions of the brush hole. Re-adjust the upper and lower positions of the brush handle.