Common faults and troubleshooting methods of hair transplanting machine-jiangmen xinhui district meixin comb manufacturing Co., ltd.

Common faults and troubleshooting methods of hair transplanting machine

　　1. The waste hair of bristle brush and wool brush is not cleaned. ① Increase the rotation speed of the roller and slow down the transmission speed of the chain; ② Move the brush closer to the roller as far as possible, as long as the needle does not touch the filling strip in the brush head and does not damage the bristles.

　　2. The wire of the wire brush is twisted and deformed. The speed of the roller is mainly reduced, and the chain transmission speed can also be adjusted faster.

　　3. The rubber chain on the bottom row simply drops off the rubber or the chain makes a strange sound. Clean up the waste hair in the double row sprocket groove in time, add lubricating oil (evenly, a little), and tighten the chain.

　　4. The brush head is simply sucked into the machine compartment. ①Regulate and press the screw to press the brush head tightly; ②Sweep the thickness of the brush head; ③The brush head cannot be a waist drum shape (the center protrudes); ④If it is a drum shape, leave between the brush head and the brush head. There are gaps.

　　 5. Inverter conditioning speed is unstable. If you use the rotary conditioning switch, it is very likely that the conditioning switch is damaged. Refer to the 'Manual-Function Parameter List' to modify the parameters, and change F0.00-0 to F0.00-1. Then use the up and down keys to set the speed.

　　 6. The sound of the machine is abnormal just after it is started. ①Perhaps lack of phase, check the circuit; ②Check the contactor, the voltage is unstable, and the contactor is simply damaged; dust entering the contactor may also cause poor contact, dust discharge or replacement of the contactor.

　　 7. The machine trips. Check the circuit and check one by one. It is very likely that a motor has burned out and shorted out. Pay attention to the lack of phase, which can easily damage the motor.

　　 8. The machine has inductive electricity, so be sure to connect the ground wire.