Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer

The bristle brush and wool brush waste hair is not clean. ① Increase the rolling speed of the roller and slow down the chain transmission speed; ② Try to adjust the brush as close as possible to the direction of the roller, as long as the needle does not touch the filling strip in the brush head, it will not damage the bristles. The filaments of the wire brush are bent and deformed, which mainly reduces the speed of the rollers, and at the same time, the speed of the chain transmission can be adjusted faster. The rubber chain in the bottom row is easy to drop the rubber or the chain makes abnormal noise, pick up the waste hair in the double-row sprocket groove in time, add lubricating oil (average, small amount), and tighten the chain. The brush head simply sucks into the compartment. ①Adjust and tighten the screw to compress the brush head; ②Remove the thickness of the brush head; ③The brush head cannot be in the shape of a waist drum (the center protrudes); ④If it is a drum shape, leave a gap between the brush head and the brush head. There are gaps. The adjustment speed of the inverter is unstable. It is very likely that the adjustment switch is damaged if the rotary adjustment switch is used. Refer to the 'Manual - Function Parameter List' to modify the parameters, and change F0.00-0 to F0.00-1, so that the speed can be set with the up and down keys. The sound of the machine just started is abnormal. ①There may be a lack of phase, check the circuit; ②Check the contactor, the voltage is unstable, it is easy to damage the contactor; the dust enters the contactor, and it is easy to cause poor contact, dust removal or exchange of the contactor. Machine tripped. Check the circuit and check one by one, it is very likely that a motor is burned out and short-circuited. Pay attention to the lack of phase, the lack of phase will easily damage the motor. The machine has induction electricity, so be sure to connect the ground wire.
https://www.mxbrushmachinery.com/