Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer57

It is to process the product continuously, without stopping in the middle, unless the 'stop' button is pressed, only when more than 2 fixtures are placed, the cyclic processing of the product can be completed. Fully automatic processing can improve production efficiency. When the product on one fixture is processed and the product on two fixtures is processed, the product on one fixture can be exchanged, and when the product on two fixtures is processed, the product on one fixture can be exchanged. products, complete the reciprocating processing. If only one fixture is placed, only semi-automatic processing can be used. In the standby state, press the number key '1' on the panel to enter the fully automatic working mode. When maintenance occurs, the entire mechanical action is stopped. After repairing, move the machine head to the high position and use the 'single step' key. Find the vacant position, and then press the 'start' button to process, otherwise, in the original processed hole position, pressing the start button to process will present a heavy hole phenomenon, which may damage the needle. Pay special attention during operation, and also during semi-automatic processing. Press the 'start' button once to process once. After the product is processed, the machine head stops at a high position and runs to the starting point. To exchange products, press the 'start' key again, run to a hole position, and process it again. It can also be processed from the beginning of N holes to a hole. N can be set. After entering the hole number through the keyboard, press the upper hole, The hole key is rotated to the hole, to ensure that the hole has not been processed, and then press the 'start' key to process, otherwise the needle will be damaged. When maintenance occurs, the treatment method is the same as that of fully automatic processing.

https://www.mxbrushmachinery.com/