Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer

Automatic processing of broom flocking machine: It is continuous processing of products without stopping in the middle, unless the 'stop' button is pressed, only when more than 2 fixtures are placed, the cyclic processing of products can be realized. Fully automatic processing can improve production efficiency when processing a product on a fixture. When processing products on two fixtures, the product on one fixture can be replaced, and when processing products on two fixtures, the product on one fixture can be replaced to realize reciprocating processing. If only one fixture is placed, only semi-automatic machining mode can be used. In the standby state, after pressing the number key '1' on the panel, it enters the fully automatic working mode. When the protection is displayed, the whole machine is stopped. After repairing, move the machine head to the high position, use the 'single step' key to find the vacancy, and then press the 'start' key to process, otherwise in the original processed hole position, press the start key During processing, there will be heavy holes, which may damage the needle. Special attention should be paid to the operation, and it should also be paid attention to during semi-automatic processing. Semi-automatic processing: Press the 'start' button once to process once. After processing the product, the machine head stops at a high position and runs to the starting point. To replace the product, press the 'start' key again, run to a hole position, and process it again, you can also process from the beginning of N holes to a hole, N can be set, you can enter the hole number through the keyboard, press the upper hole, the down Move the hole key to the hole, make sure that the hole has not been processed, and then press the 'start' key to process.
https://www.mxbrushmachinery.com/