Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer27

1. Direct hair planting on the hair planting machine This is the most traditional way, which is to plant nylon yarn and abrasive yarn directly on the grinding roller. Advantages: good strength, short manufacturing cycle. Disadvantages: The cost of hair planting is high, and local replacement cannot be performed, which is a helpless choice in the initial stage. 2. Nylon sleeve Advantages: The production process is simple. Now it is the main production method of high temperature resistant nylon silk brush roller. Disadvantages: If it is made of nylon of poor quality, the thermal expansion and contraction of nylon will cause the nylon to become longer, so that the nylon at both ends of the roller body will grow out of the sanding roller and withstand the machine, which will also cause the nylon sleeve to burst and crack, making the whole sanding The roller is scrapped; the use of riding studs to plant bristles is not high in strength and easy to depilate; the strength of nylon is not high, and the planting density cannot be increased, etc... It can be wound on the metal strip, and then wound on the sanding roller, which can be customized according to the length of the sanding roller. It is now the main production method of abrasive silk brush rollers. Disadvantages: Because the abrasive wire is stuck on the metal strip, it will lead to the phenomenon of wire drawing (the abrasive wire is pulled out), the strength is not high, and only two ends are fixed after winding, so it is difficult to make it tight in the middle, if one end is loose If it falls off, it will cause an accident. The new double steel belt winding has a lot of improvement compared with the ordinary winding function, but the cost is higher. 4. Aluminum alloy brush roller - the advantages of the new type of brush roller: the brush roller produced is made of aluminum alloy cylinders spliced ​​together, and the brush roller of any length can be customized; the high-strength aluminum alloy substrate can make the flocking density the highest, and the The most advanced hair planting technology, no hair removal, and no cracking and lengthening like nylon; the roller body can accurately check the dynamic balance. Disadvantages: The manufacturing cost is too high, the technical requirements for workers are relatively high, and it is not suitable for the manufacture of brush rollers with metal wires as materials.

https://www.mxbrushmachinery.com/