Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer24

When installing, it should be noted that the photosensitive drum is usually divided into left and right. After the end with the gear is installed, use the fixing pin that has just been removed to install the photosensitive drum. The brand-new photosensitive drum generally has an ink-colored anti-exposure seal. Do not tear it off before installation to prevent exposure. The brush roller can be torn off after it is installed and checked. In this way, the powder supply part and the collection part of the brush are completed separately. Finally, as long as the two parts are installed and restored according to the situation when they were disassembled, and the fixed latch is inserted, the whole replacement work is completed. Let's take a look at the collection section, where all we have to do is replace the new photoconductor drum. Use the same method to pull out the fixing pins, take out the photosensitive drum, and then clean up the waste toner in the waste toner collection part (as clean as possible, so as not to affect the printing quality of the new drum), at this point, we can install the new photosensitive drum . First look at the toner supply part. The strip brush first unscrew the screw on the gearless side of the magnetic roller, open the plastic cover, and then clean all the toner in the toner bin and on the magnetic roller with a soft brush roller. Then re-install the magnetic roller and press it firmly to prevent the magnetic roller from falling out of its original position. At this time, the toner can be loaded. The brush roller shakes the toner evenly and slowly pours it into the toner supply bin. Use the good parts to fix the magnetic roller. Conducive to the uniform attachment of toner.

https://www.mxbrushmachinery.com/