Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer15

The hair planting machine in the brush-making equipment is a very common one, and there are many products that can be planted, including toothbrushes, hair brush machine factory, shoe brush machine factory, hair hubs, etc. The brush products that can be produced by the hair planting machine can be used in various places. applied in various fields. Today, the editor of Lanbang is discussing with you the analysis of the factors that the quality of the products produced by the hair planting machine is not satisfactory. The reasons why the quality of the hair-planting machine products in the brush-making equipment is not good enough: First: the copper wire is simply bent 1. The copper-cutting part of the hair-planting machine head is worn out and replaced. 2. The copper cutting knife is worn and replaced. 3. If the hair planting head and the copper cutting knife are not adjusted properly, adjust them from scratch. 4. If there is a foreign body on the contact surface between the hair-planting head and the hair-planting head, remove it and remove it. 5. If the height of the copper cutting knife is not adjusted properly, adjust it from the beginning; if the copper wire is adjusted too long, shorten the copper wire. 6. The copper wire is of poor quality, such as bent, too wide or too thick, replace the new copper wire. Second: the size of copper wire of the hair planting machine, the length of the copper wire after cutting is different. 1. The copper wire clip is worn, and it should be reground or replaced. 2. The copper wire backstop is worn, and the copper wire backstop is used or replaced. Third: The point of view of the copper wire entering the brush handle is wrong when the hair is planted, resulting in the copper wire not being able to get stuck on the bristles or the copper wire being simply dropped. 1. The size of copper wire, refer to the size of copper wire. 2. The copper wire adjustment is too short. 3. When planting hair, the distance between the hair planting head and the brush handle is too large, adjust the distance between the front and rear. 4. The front end of the hair-planting needle is worn, smoothed or replaced. 5. The front end of the hair-planting head is worn out, and the hair-planting head is replaced. Fourth: Insufficient bristle pulling force of the hair planting machine. 1. The copper wire is too short, adjust the length. 2. If the depth of hair planting is not good, adjust the length of the hair planting needle. The length of the bristles is not uniform (all), the upper and lower positions of the brush holes are not adjusted properly, and the brush handle is adjusted from the beginning. Up and down, the height of the bristles in the orientation is not properly adjusted, and the height of the bristles and the bristles are adjusted. The above is the analysis of the reasons why the quality of the flocking machine products in the brush-making equipment is not satisfactory. Through our analysis, I believe that you have an understanding of the reasons and solutions. If you know more about the introduction of brush-making equipment, welcome Contact our online customer service staff.

https://www.mxbrushmachinery.com/

looking for the best deal while getting a quality is usually the number-one objective for most About MEIXIN Brush Machinery Factory manufacturer.

During JIANGMEN MEIXIN COMB BRUSH MAKING MACHINE FACTORY’s existence in a market we didn’t receive any negative feedback from our customers.

JIANGMEN MEIXIN COMB BRUSH MAKING MACHINE FACTORY's BRUSH MAKING MACHINE FACTORY are sturdy, easy to operate, friendly work machines that deliver high-quality About MEIXIN Brush Machinery Factory for About MEIXIN Brush Machinery Factory purposes.