Woodworking machinery dust removal machine belt brush-transmission dust removal belt brush production method_faq

The method of making belt brushes Firstly, after punching holes on the belt, fold the brush filaments in half and thread them on the belt with nylon thread, and then trim the bristles. Because of the softness of the belt, its manufacturing process seems simple, but it is really troublesome to manufacture. Especially the planting stage is done by experienced employees alone. At present, there is no advanced equipment for mass production in China. General machinery Can't operate at all. Firstly, after punching holes on the belt, fold the bristles in half and thread them on the belt with nylon thread, and then trim the bristles. The application of belt brushes should be used in special production lines to transport products or dust removal operations through belt brushes; wood industry, machinery manufacturing, food industry, sanitation industry, hardware industry, electronics industry, etc. Some belt brushes are not only used in industrial production, but a small amount of them are turned into handicrafts and enter the field of collection. The characteristics of belt brushes At present, because the domestic belt brushes are made by hand, the nylon thread for stringing will inevitably be exposed on the back, but there is no need to worry that the nylon thread for stringing will be broken. Usually the quality of the nylon thread for stringing is similar. For fishing line, it is very tough and abrasion resistant. There are two types of belts: long strip and ring. The color is gray, red, green, etc., and the width depends on different equipment. The hair length on the belt brush is also controllable, and its length can be set when used in different equipment. Belt brush: timing belt brush and flat belt brush. When the belt brush is made, holes are punched on the belt and then nylon brush filaments or bristles are implanted, which is used for equipment cleaning or product delivery. The production process of domestic belt brushes is mostly in the form of manual threading. First, after punching holes on the belt, the brush filaments are folded in half and threaded on the belt with nylon thread, and then the bristles are trimmed. The disadvantage is that the wires exposed on the back are easy to fray, causing the brush filaments to loosen and shed hair. After many times of research and development and the cooperation of many customers, our company has developed a special belt brush numerical control tufting equipment. The brush wire is fixed firmly, the technology is mature, the product is neat and beautiful, and the bristles are flat, which is even better than the imported belt brush. Synchronous belt brushes are usually used in the transportation of liquid crystal panels and electronic products, which can effectively reduce and avoid employee damage to products during transportation on the production line. The timing belt is usually made of polyurethane (PU) material, and the belt interlayer is a steel wire layer to enhance the tension of the belt. The bristles are made of nylon filament (PA6PA66PA610PA612), white or black, and the bristles must be thin, soft and tough. The belt brush is made by computer numerical control punching and tufting technology, which solves the phenomenon that the traditional threaded belt brush is loose and dropped due to the wear or break of the thread exposed on the back of the belt. Mechanized production not only improves the quality of products, but also makes them more enjoyable and practical. The hair bundles are evenly distributed, the hairs are neatly flat, and the brush filaments are firmly fixed. The belt thickness is 6mm or 7mm, the brush wire is high-quality nylon wire (black, white), the wire diameter is 0.1mm, 0.15mm, 0.2mm, etc., the front length is 10-20mm, and the hole diameter is 2mm. Welcome to log in; www.mxbrushmachinery.com