The reason why the hair planting machine causes defective products-Company news-CNC hair planting machine, flat hair machine, flat wire machine, brush machine, industrial brush machine manufacturer, MX

First: The copper wire is simply bent 1. The copper part of the hair-planting head is worn and replaced. 2. The copper cutting knife is worn and replaced. 3. Improper adjustment of the hair-planting head and the copper-cutting knife, adjust it from scratch. 4. There is a foreign body on the contact surface between the hair-planting head and the center of the hair-planting head, remove it and remove it. 5. If the height of the copper cutting knife is not adjusted properly, adjust it from the beginning; if the copper wire is adjusted too long, shorten the copper wire. 6. The quality of the copper wire is poor, such as twisting, too wide or too thick, replace the new copper wire. Second: The copper wire size of the hair planting machine is different in length after the copper wire is cut. 1. The copper wire clip is worn, and it should be reground or replaced. 2. The copper wire backstop is worn, and the copper wire backstop is used or replaced. Third: When the hair is planted, the point of view of the copper wire entering the brush handle is wrong, so that the copper wire cannot be stuck on the bristles or the copper wire is easily adjusted. 1. The size of copper wire, refer to the size of copper wire. 2. The copper wire adjustment is too short. 3. When planting hair, the distance between the hair planting head and the brush handle is too large, adjust the front and rear intervals. 4. The front end of the hair-planting needle is worn, smoothed or replaced. 5. The front end of the hair-planting head is worn out, and the hair-planting head is replaced. Fourth: the lack of bristle pulling force of the hair planting machine. 1. The copper wire is too short, adjust the length. 2. If the depth of hair planting is not good, adjust the length of the hair planting needle. The length of the bristles is not uniform (all), the upper and lower positions of the brush holes are not adjusted properly, and the brush handle is adjusted from the beginning. If the height of the bristles is not properly adjusted up and down, adjust the height of the bristles and the bristles. Previous: How to maintain the drilling machineNext: How to maintain the brush-making machinery and equipment