Flocking machine-electrostatic flocking (velvet) printing process operation requirements_Latest news

1. Electrostatic flocking (velvet) is a relatively complicated process in printing, and all aspects of operation and preparation work must meet certain requirements.

1. Select fine flocking (velvet) pulp
Excellent electrostatic flocking (velvet) pulp plays a very important part in the flocking process. Fuli Environmental Protection (829) flocking (velvet) pulp has excellent performance, has the characteristics of good firmness, soft hand feeling, and easy operation.
2. A suitable electrostatic tufting machine is required
The power output of the tufting machine must be adjusted according to the site. The quality of a tufting machine directly affects the premise of the tufting process.
3. High-quality fluff
A: Purchasing high-quality fluff requires scientific selection (how to judge whether the fluff will fade), etc. There are several types of fluff, and there are lengths, so it needs to be purchased appropriately.
B: The fluff changes with the weather. Whether the fluff meets the dry and wet requirements during operation also needs to be adjusted according to the current situation. Whether it needs to be dried and humidified is a good preparation process for wool planting.
This article comes from Foshan MX brushmachinery Machinery Factory

Second, the correct process

1. The reasonable application of flocking (velvet) pulp is very important in the flocking process. First, add a certain amount of Fuli (808) additives (1.5%-2%) or additives when using the flocking (velvet) pulp Add 1:1 water to mix and stir, and then add to the slurry and stir evenly. The prepared slurry must be used immediately and cannot be left for a long time (within 8 hours), otherwise cross-linking will occur at normal temperature and affect the use. This is Things to pay attention to during operation. If the flocking pulp is too thick during printing, it can be diluted by adding an appropriate amount of water, which will help good operation.
2. It is recommended to use mesh 800 mesh (80 mesh) for plate making and screen printing: pay attention to the time between the last printing of flocking (velvet) pulp and the time of flocking operation, there must be no interval of 1 minute, and the number of printings depends on the relevant fabric , time and other factors are adjusted.
3. Let the fabric dry naturally, and after 24 hours, it can be washed with 60°C ordinary water. If the customer requires strict quality, it must be baked at 160°C for 10-60 seconds. Of course, the temperature and time of baking must also be adjusted according to the relevant fabrics and requirements.
4. The final process of fabric wool planting is to clean the tail process. After using the hair suction machine to absorb the wool, the remaining wool products are glued to the fabric with adhesive tape and shipped.