Cleaning equipment for processing LOW-E insulating glass in the glass industry

The H180W0/1600T/S series of washing machines are designed to adapt to different glass processing. According to different uses, this series of washing machines can be flexibly configured. T series are suitable for cleaning and pretreatment of coating, laminated, solar glass, tempered and LOW-E insulating glass. Type S is a simplified version, and the two series of mechanisms are basically the same, with different configurations. The structural characteristics of this cleaning machine (T series) 1. The feed section is equipped with pre-cleaning, which can pre-wash the film particles and dirt on the edge of the LOW-E glass and soak the conveyor roller. 2.3 groups of high-quality nylon brushes, bristles diameter: ****, two pairs 0.15-0.18mm, third pair 0.08-0.10mm, can clean offline LOW-E glass or online LOW-E glass. (The three sets of brushes can be lifted by the cylinder, and the type of brush can be selected for cleaning different types of glass. It is suitable for cleaning off-line (LOW-E glass). 3. The conveyor roller of the whole machine adopts a fully encapsulated vulcanized rubber roller to facilitate glass transmission. 4. The cleaning and air drying adopts gear transmission, which is stable and reliable. 5. The main drive is steplessly adjusted by the frequency converter, which can be quantified and adjusted according to specific conditions. 6. The upper cleaning chamber can be raised and lowered electrically, and the thickness of the glass can be displayed digitally. 7. The upper cleaning chamber can be raised 400mm, easy to replace parts or maintenance equipment, with overhaul alarm device, when the machine rises or falls, the alarm light flashes to remind personnel to pay attention to safety 8. The brush is driven by the belt, and the noise is low. 9. The water system has 3 stainless steel water tanks/stainless steel The water pipe adopts the design of circulating water to ensure the cleanliness of the last spray water. 10. Under normal conditions, the water and wind are not heated to keep the glass transparent. 11. Equipped with a high-pressure and low-noise fan with a noise of ≤80 decibels. The fan is framed The steel structure is supported on the upper part of the machine, equipped with a fine filter device and a maintenance ladder, which is convenient for personnel to go up and down and the drying section is equipped with 2 sets of special structure air knives with a three-stage design. 12. The upper and lower guide table and the cleaning and drying section are installed separately, which is convenient for transportation.