It is to process the product continuously, without stopping in the middle, unless the 'stop' button is pressed, only when more than 2 fixtures are placed, the cyclic processing of the product can be completed. Fully automatic processing can improve the production efficiency. When the product on the first fixture is processed and the product on the next fixture is processed, the product on the first fixture can be replaced, and when the product on the next fixture is processed, it can be replaced. The products on the fixture are completed reciprocating processing. Assuming that only one fixture is placed, only semi-automatic machining can be used. In the standby state, press the number key '1' on the panel to enter the fully automatic working method. When maintenance occurs, the entire mechanical action is stopped. After repairing, move the machine head to the high position and use the 'single step' key. Find the vacant position, and then press the 'preliminary' button to process, otherwise, in the original processed hole position, pressing the preliminary button will cause heavy holes, which may damage the needle. Be careful when operating, and you should also pay attention to semi-automatic processing. Press the 'preliminary' key once to process once. After the product is processed, the machine head stops at the high position, and the work reaches the starting point. To exchange products, press the 'preliminary' key again, work to the first hole position, and process it again, it can also be preliminarily processed from the Nth hole to the final hole, N can be set, after entering the hole number through the keyboard, press the Press the 'Preliminary' button to process it, otherwise the needle will be damaged. When maintenance occurs, the treatment method is the same as that of fully automatic processing. After setting the data of the product, in the automatic test machine screen, press the 'up hole' or 'down hole' key to complete the single-step hole alignment, you can check whether the orientation of the hole is wrong, if it is wrong, you can exit, Enter the experience modification interface to stop modification. According to the preliminary, the workbench will continue to move until a product program file is finished and the work is terminated, so that it can be checked whether the workbench is normal. https://www.mxbrushmachinery.com/
