Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer

It is necessary to keep the guide rails and screw rods clean at all times to prevent debris from adhering to the guide rails or screw rods and affecting the accuracy of the machine's operation and positioning. Avoid working in an electric fume box in a humid environment and prevent violent vibration in the electric fume box. Avoid tapping the touch screen with hard objects, which will reduce the flexibility of the screen and even break the glass screen. Do not pull the cable too hard. There is high voltage in the electrical box. When defective, non-technical personnel shall not disassemble it to avoid electric shock or damage to system data. Operators often need to add lubricating oil to the various moving parts of the hair planting machine to reduce wear between machines. The operator should regularly check whether the screws are loose, assuming they should be tightened in time. The electrical box cannot be operated in a strong electromagnetic field environment, otherwise it may present an uncontrolled situation. The input power wiring is correct (the red, blue and yellow lines are connected to the 380V three-phase line respectively, the green line is connected to the neutral line, and the yellow and green three-phase lines are connected to the neutral line) to the ground line). The voltage stabilizer outputs 200 volts AC to provide a 100 kV transformer, one end of the transformer is grounded, and the other end is connected to the screen inside the wooden box. Put the bucket containing the glue that has been mixed into the mixing bucket, then tighten the lid of the bucket, then connect the air source and the spray gun, then turn on the air source, and first let the electric fan in the mixing bucket stir the glue. average. Put the plastic parts that need to be flocked into the glue mold, then put them into the air extraction box, open the shotcrete box, spray a lot of glue on the glue parts, and then take the glue parts from the glue mold. Come out and put it on the pendant stick. Put the wooden stick into the hair planting box, step on the switch, connect the power supply, and make the screen absorb the fluff under the high voltage of static electricity. Then put the part that needs to be planted down and swing against the fluff, so that the fluff can reach evenly and fully absorb the glue for a period of time.
https://www.mxbrushmachinery.com/