Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer

In our daily life, the process of hair planting has become very common. What is the operation process of the hair planting machine? 1. The voltage regulator outputs 200V alternating current to supply power to the 100kV transformer. One end of the transformer is grounded, and the other end is connected to the screen inside the wooden box. 2. Put the bucket containing the mixed slurry into the mixing bucket, tighten the bucket cover, connect the air source and the shotgun, then turn on the air source, and mix the slurry evenly with the electric fan blades in the mixing bucket. 3. Put the rubber parts that need hair planting into the plastic mold, then put them into the air extraction box, open the spray box, spray a lot of glue on the rubber parts, and then take the rubber parts out of the plastic mold, Then put it on top of the hanging stick. 4. Put the wooden stick into the hair planting box, step on the switch and turn on the power, so that the screen absorbs the fluff under static high pressure. Then put down the part that needs to be planted, and constantly swing against the fluff, so that the fluff reaches an average level within a period of time and fully absorbs the rubber sheet. 5. Put the glue laid with wooden sticks into the oven to dry. 6. Take out the stick from the stove, then take out the film from the stick and put it away. When the film cools down to room temperature, start cleaning the flocked surface. Matters needing attention for hair planting: 1. Add lubricating oil to each moving part of the hair planting machine in each shift to reduce mechanical wear. 2. Regularly check whether the screws are loose and fasten them in time. 3. Keep the guide rail and screw clean to avoid sundries sticking to the guide rail or screw, which will affect the positioning accuracy. 4. Ensure that the electric box is in a ventilated environment, avoid humid or high temperature environment, and prevent the electric box from vibrating violently. 5. The electric box can no longer be in a strong electromagnetic field environment, otherwise it may be out of control. 6. The wiring of the input power supply is correct (the red, blue and yellow wires are respectively connected to the 380V three-phase wire, the green wire is connected to the neutral wire, and the yellow and green wires are connected to the ground wire). Pin numbers: 1, 2, and 3 are 380V phase lines, 4 neutral lines, and 5 ground lines. The voltage should be stable and kept at ac380-10v. Too high voltage may cause the electronic components to burn out. 7. It is forbidden to touch the touch screen with hard objects, otherwise the sensitivity will be reduced, and even the glass screen will be damaged. 8. Do not pull the cable hard. 9. There is high voltage in the electric box. In case of failure, non-professionals are not allowed to disassemble it to avoid electric shock or even damage to system data.
https://www.mxbrushmachinery.com/