Brush making equipment - automatic flat hair machine - flat hair flowering machine - high-speed hair planting machine manufacturer

Brush-making equipment Hair-planting machines are available in many brush-making factories. There are various processing methods, such as mechanical/semi-automatic/full-automatic. Today, the editor of Lanbang CNC will introduce to you several processing methods about the hair planting machine. Mechanical type It is to process the products one after another without stopping the center. Unless the 'Abort' button is pressed, the cyclic processing of the product can be completed only when more than 2 fixtures are placed. Fully automatic machining can improve production efficiency. When the product on the first fixture is processed and the product on the second fixture is processed, the product on the first fixture can be replaced, and the product on the second fixture can be processed. Replace the product on the first fixture to complete the reciprocating process. If only one fixture is placed, only semi-active machining mode can be used. In the standby state, press the number key '1' on the panel to enter the fully active working mode. When maintenance occurs, the entire mechanical action is stopped. After repairing, move the machine head to the high position, and use the 'single step' key to find If there is a vacant position, then press the 'start' key to process, otherwise, in the originally machined hole position, pressing the start key will cause a heavy hole phenomenon, which may damage the needle. You must pay attention to it during operation, and you should also pay attention to semi-automatic processing. Semi-automatic Press the 'Start' button once to process once. After the product is processed, the machine head stops at the highest position, and the work reaches the starting point. To replace the product, press the 'Start' button again, work to the first hole position on the list, and process it again, and it can also be processed from the beginning of the Nth hole to the last hole, N can be set, and can be input through the keyboard. After the hole number, press the Press the 'Start' button to process the hole, and then press the 'Start' button to process it, otherwise the needle will be damaged. When maintenance is performed, the treatment method is the same as that of the fully automatic machining. After the fully automatic teaching of the product data, in the fully automatic test screen, press the 'up hole' or 'down hole' button to complete the single-step hole alignment, and you can check whether the position of the hole is wrong. Exit and enter the lesson correction interface to make corrections. After pressing start, the workbench will continue to move until a product program file is finished to stop the work, which can test whether the workbench is normal.
https://www.mxbrushmachinery.com/